In the rainy season caused a lot of computers to jangojang, mostly due to dust and moisture, damaged or faulty parts, you may receive a variety of symptoms.
Another problem is that the computer was originally geotinde tteuteoboni video card cooler and a lot of dust on the main board was stuck. At least in a very unstable state of the moisture is faded.
Fortunately, because is still a working cleaning is not really a problem if you seem nice to me.
42 CPU cooler and the heat sink is fully covered in the dust, because the CPU is a difficult situation to control the temperature properly.
This cooler attached to it where all the dust ... PSU from the outside than the inside is covered with more dirt.
Of course we have to have to clean the dust between the heatsink and CPU coolers on the market include a dust remover to clean it is not. Thin tweezers, etc. before it is recommended to scrape the dirt gently.
(All except the line at the back of your computer when you do clean up. Especially the power cord, monitor, connection cables, etc. I removed, please.)
Now, using the dust remover to remove the remaining dust. Attach the heat sink close to the end of this time the air injector, it is less dust. In the same way to clean a video card.
Cleaning inside the computer is completed. Were cleaned with a large air compressor but it did not cool enough for end use will not cause a problem because the dirt is.
Finally, using the air eliminator is cleaned using high pressure gas is somehow I saw that part where he focused on the water sprayed arose.
Sometimes after cleaning the air eliminator, or to destroy the main board but maybe I've seen this problem did not occur as a board short that has come to assume.
For a long time enough to discourage a lot of water has occurred.
As the air eliminator to clean your computer to write this part seems to care.
"
This blog article was created using Google Translator.
0 개의 덧글:
Post a Comment